Installing vinyl stickers is not rocket science. It is a very simple task that can be accomplished by following a few steps mentioned below. So check out the post-step list for the correct methods to install your dream printed vinyl stickers.
[Step-1] Find a perfect surface:
Before taking any other steps to install a printed window sticker or a vinyl sticker, one should make sure that it has a clean, smooth and dry surface. It is important because if you stick your car window decal on a dirty surface, the glue that is adhered to the back of the decal will pick up that dirt with it, which in turn will not allow the decal to set with its surface. adequately.
[Step-2] Clean the surface properly:
If the surface is not clean enough, then your next job is to make the surface flawless, dirt-free, non-greasy, and crystal clear. The best surface cleaner available, in this case, is isopropyl alcohol, especially since it dries in just a few seconds and leaves no residue. You can also use other common cleaners such as water, household detergent, and any other dry cleaners. However, do not use harsh cleaners like Windex. They often leave a lot of residue and do not allow the sticker to adhere well.
[Step-3] Check the area:
Once you are done with the tasks mentioned above, mark a particular area of the entire clean surface. Use masking tape to mark the required measurement, usually from left to right and top to bottom. Now leave this as is.
[Step4] Take off that white paper:
All kinds of promotional decals or vinyl stickers are often attached to a white backing paper that actually protects the adhesive on the decal from air and moisture. Here, you need to slowly peel off that white background and pull out the actual sticker.
[Step5] Attach the sticker:
Now slowly place the promotional window decal inside the marked area and affix it there. Be sure to rub the surface of the sticker with a squeegee or credit card. This will remove any air bubbles under the surface of the sticker.
[Step6] Peel the clear tapes:
Last but not least, slowly remove the clear clear tape, at a comfortable angle. Please do it slowly and do not pull the sticker from its surface.
[Step7] A little extra care:
You can use a pin or a pointed object to pry out the existing bubble. For best results, do not attempt to adhere the sticker in an extremely hot or extremely cold environment. The preferable temperature for applying these car window decals is 70 degrees Fahrenheit.
